Upkeep handbook of the laser etching machine

As we know, the smoke and dust which is produced by the engraving as well as cutting will certainly harm the guide rail after a period of usage, so we should do the day-to-day upkeep of the guide rail. Please shut off the laser engraving machine and reduced the power, clean the guide rail with tidy review, after that please drop the lubricating oil on the overview rail, aim to removal the slide rod and make sure that the oil enters into it. Make the slide rod move on the guide rail after filling up the oil, currently we should set up the guide rail firstly, please do not take care of the overview rail to start with, install the screws in the best position as well as maintain the slide ray on the even degree. After that fix the belt as well as slide pole well, set up the lens and afterwards adjust the destination of x light.

CO2 laser cutting machine

After a duration of usage of the laser inscription and also laser cutting machine, the smoke as well as dust will certainly follow the surface area of the reflector and also mirror, which will impact the inscription as well as cutting deepness and also will certainly affect the inscription as well as cutting accuracy. We should cleanse the three reflectors as well as one concentrating mirror with pure alcohol weekly. A laser etching machine is outfitted with lots of bearings, in order to maintain the good inscription as well as cutting result, component of bearings need to be filled up with oil frequently except the oil-retaining bearing. Wipe off the surface dirt on the bearing with the tidy mull, take a piece of injector as well as draw some engine oil inside, after that fill up the bearing with pinhead as well as removal the bearing at the same time.

There are some concurrent belts on one laser inscribing review of Boss machines, if the synchronous belt is also loosened which will certainly cause the dual pictures of the engraved words, if the synchronous belt is too tight which will cause the abrasion of concurrent belt. After duration of usage, please adjust the taut screws of concurrent belt, change the concurrent belt till its degree of tightness is suitable, it suffices when there are no double pictures of the engraved words as well as the noise of the laser engraving as well as laser cutting machine is much reduced, or you can consult our technician.